ACC SHELL

#!/bin/sh
#
### BEGIN INIT INFO
# Provides:          portmap rpcbind
# Required-Start:    $network $syslog
# Required-Stop:     $network $syslog
# Default-Start:     3 5
# Default-Stop:      0 1 2 4 6
# Short-Description: TI-RPC program number mapper
# Description: TI-RPC program number mapper
### END INIT INFO
# 
RPCBIND_BIN=/sbin/rpcbind
test -x $RPCBIND_BIN || { echo "$RPCBIND_BIN not installed"; 
	if [ "$1" = "stop" ]; then exit 0;
	else exit 5; fi; }

. /etc/sysconfig/rpcbind

. /etc/rc.status

# Reset status of this service
rc_reset

case "$1" in
    start)
	echo -n "Starting rpcbind "
	/sbin/startproc $RPCBIND_BIN $OPTIONS $RPCBIND_OPTIONS

	rc_status -v
	;;
    stop)
	echo -n "Shutting down rpcbind "

	/sbin/killproc -TERM $RPCBIND_BIN

	rc_status -v
	;;
    try-restart|condrestart)
	## Do a restart only if the service was active before.
	## Note: try-restart is now part of LSB (as of 1.9).
	## RH has a similar command named condrestart.
	if test "$1" = "condrestart"; then
		echo "${attn} Use try-restart ${done}(LSB)${attn} rather than condrestart ${warn}(RH)${norm}"
	fi
	$0 status
	if test $? = 0; then
		# do a warmstart in this case, keeping the state
		OPTIONS="-w" $0 restart
	else
		rc_reset	# Not running is not a failure.
	fi
	# Remember status and be quiet
	rc_status
	;;
    restart)
	## Stop the service and regardless of whether it was
	## running or not, start it again.
	$0 stop
	$0 start

	rc_status
	;;
    force-reload)
	$0 try-restart
	rc_status
	;;
    reload)
	# rpcbind does not support reload on signal
	rc_failed 3
	rc_status -v
	;;
    status)
	echo -n "Checking for service rpcbind "
	/sbin/checkproc $RPCBIND_BIN

	rc_status -v
	;;
    *)
	echo "Usage: $0 {start|stop|status|try-restart|restart|force-reload|reload}"
	exit 1
	;;
esac
rc_exit